Planet FSD-401SC, Manual

Page: 13 / 26

SOHOConnect Series 8
Rear Panel
Power Inlet
The rear panel of the Switch indicates a 100~240VAC Power inlet for
the Switch
Figure 2. Rear Panel of FSD-401
Power Notice:
1. The device is a power-required device, it means, it will not work till
it is powered. If your networks should active all the time, please
consider use an UPS (Uninterrupted Power Supply) for your device.
It will prevent you from network data loss or network downtime.
2. In some area, installing a surge suppression device may also help to
protect your hub from being damaged by unregulated surge or
current to the Switch or the power adapter.
Hardware Installation
1. Place the Switch on a smooth surface
2. Connect the power cord to the switch and with the other end to the
power.
3. Connect hub or PC to one port of the Switch using Category 3/4/5
UTP/STP cabling.
4. Connect another hub or PC to the other port of Switch by following
the same process as described in Step 3.
5. Connect the multi-mode fiber cable (62.5/125ì m or 50/125ì m)
with correct connector (either ST or SC) from the Switch to your
100Bas-FX Ethernet device (with TX/RX crossed)
6. Set the duplex mode of the Switch and the fiber device. Power on