11
Step 2.
Installing battery
Battery
DC
DC
Battery DC Input: 24V , 10A
PV DC Input: 24-45V , 8.8A max.
Max. Alarm Loading: 24V, 1A
1 2 3 4 5 6
Bat.In/Out
1. Connect the
negative electrode of the battery
to the terminal for the
nega-
tive electrode of the battery on the BSP-360
.
By default, the lithium battery
is in use.
2. Connect the
positive electrode of the battery
to the terminal for the
positive
electrode of the battery on the BSP-360
.
3. After the battery is well connected to the BSP-360, the
PWR LED will be ON
and
System LED will slowly blink
, and
Alarm LED will slowly blink
.
The BSP-360 accepts the
24V DC
battery system. Please pay
attention to the battery characteristics and also refer to the section
--
Recommended Settings for Different Batteries
in the Quick
Installation Guide.
Note
Be noted for the thickness of electric wire and please refer to the
section --
Recommended Use of the Connected Wires
in the
Quick Installation Guide.
Before the first installation
The lead-acid battery default
LVD (Low Voltage Disconnec-
tion) is
set at
22.2V DC
; we suggest charging the voltage of
battery to
23.5V DC or above
for the BSP-360.
The lithium battery default
LVD (Low Voltage Disconnec-
tion) is
set at
21.3V DC
; we suggest charging the voltage of
battery to
24V DC or above
for the BSP-360.
Check the total power consumption of your connected network
device before installation. Improper battery capacity could shorten
the battery life or make your network device lack of power supply.
Summary of Contents for BSP-360
Page 24: ......