3.4.2.1 WAN
Click
WAN
in the left pane, the page shown in the following figure appears.
In this page, you can configure WAN interface of your router.
The following table describes the parameters of this page:
Field
Description
Default Route Selection You can select
Auto
or
Specified
.
VPI
The virtual path between two points in an ATM network,
ranging from 0 to 255.
VCI
The virtual channel between two points in an ATM
network, ranging from 32 to 65535 (1 to 31 are reserved
for known protocols)
Encapsulation
You can choose
LLC
and
VC-Mux
.
Channel Mode
You can choose
1483 Bridged
,
1483 MER
,
PPPoE
,
PPPoA
, or
1483 Routed
.
Enable NAPT
Select it to enable Network Address Port Translation
(NAPT) function. If you do not select it and you want to
access the Internet normally, you must add a route on the
uplink equipment. Otherwise, the access to the Internet
fails. Normally, it is enabled.
Enabel IGMP
You can enable or disable Internet Group Management
Protocol (IGMP) function.
PPP Settings
User Name
Enter the correct user name for PPP dial-up, which is
provided by your ISP.
Password
Enter the correct password for PPP dial-up, which is
provided by your ISP.
Type
You can choose
Continuous
,
Connect on Demand
, or
Manual
.
Idle Time (min)
If set the type to
Connect on Demand
, you need to enter
the idle timeout time. Within the preset minutes, if the
40
