User’s Manual of WGSW-28040
■
Reset Button
At the left of front panel, the reset button is designed for reboot the Managed Switch without turn off and on the power. The
following is the summary table of Reset button functions
:
Reset Button Pressed and Released
Function
< 5 sec
: System Reboot
Reboot the Managed Switch.
> 5 sec
: Factory Default
Reset the Managed Switch to Factory Default configuration.
The Managed Switch will then reboot and load the default
settings as below:
。
Default Username:
admin
。
Default Password:
admin
。
Default IP address:
192.168.0.100
。
Subnet mask:
255.255.255.0
。
Default Gateway:
192.168.0.254
2.1.2 LED Indications
The front panel LEDs indicates instant status of port links, data activity and system power; helps monitor and troubleshoot when
needed.
Figure 2-1-2
shows the LED indications of these Managed Switches.
LED Indication
Figure 2-1-2
WGSW-28040 LED panel
■
System
LED
Color
Function
PWR
Green
Lights
to indicate that the Switch has power.
SYS
Green
Lights
to indicate the system is working.
Blink
to indicate the system is booting.
■
10/100/1000Base-T interfaces
LED
Color
Function
Lights
: To indicate the link through that port is successfully established.
LNK/ACT
Green
Blink:
To indicate that the switch is actively sending or receiving data over that port.
Lights
:
To indicate that the port is operating at
1000Mbps
.
1000
Orange
Off:
If LNK/ACT LED light-> indicate that the port is operating at
10/100Mbps
If LNK/ACT LED Off -> indicate that the port is link down
19
