Hybrid
Digital
Video
Recorder
HDVR
series
36
5.3.1 Motion Detection
When system detects the motion signal that reaches the set sensitivity, the motion detection
alarm is on and the linkage function is turned on. The details are shown below.
Digital channel:
It not only enables motion detection function at the local side, but also
enables the remote device that is connected. When remote device detects motion movement,
the local side will start alarm recording, provided this function is not enabled.
Picture 5.4 Motion Detection
Channel
Choose the set motion detection channel.
Enable
The motion detection function is on when the box is checked.
Sensitivity
Six options are provided in the sensitivity.
Only the motion detection in hybrid mode/full
analog mode has this function of setting sensitivity,
and also only the analog channel can set region.
Region
Click the set button to enter the set area. The area is divided
into PAL 22X18. Red block means the motion is being detected
in the defensive area. White block means the unfenced area.
You can set the area as follows: Drag the mouse and draw the
area. Default: all selected blocks are detection areas.
Only the motion detection in hybrid mode/full
analog mode has this function of setting region,
and also only the analog channel can set region.
Period
Trigger the motion detection signal in the time section. You can
set by week or set uniformly. Each day is divided into four time
sections.
