3
1. Choose an Installation Site
Select a suitable place on the network to install the ADW-4302.
NOTE:
For best Wireless reception and performance, the ADW-4302
should be positioned in a central location with minimum ob-
structions between the ADW-4302 and the PCs. Also, if us-
ing multiple Access Points, adjacent Access Points should use
different Channels.
2. Connect LAN Cables
Use standard LAN cables to connect PCs to the Switching Hub ports on the
ADW-4302. Both 10Base-T and 100Base-TX connections can be used simul-
taneously.
If required, connect any port to a normal port on another Hub, using a stan-
dard LAN cable. Any LAN port on the ADW-4302 will automatically function as
an “Uplink” port when required.
3. Connect ADSL Cable
Connect the supplied ADSL cable from to the WAN port on the ADW-4302 (the
RJ-11 connector) to the ADSL terminator provided by your phone company.
4. Power Up
Connect the supplied power adapter to the ADW-4302 and power up.
Use only the power adapter provided. Using a different one may cause hard-
ware damage.
5. Check the LEDs
• The PWR LED should be ON.
• The STATUS LED should be flash, then turn Off. If it stays on or blinking after
60 seconds, there is a hardware error.
• For each LAN (PC) connection, one of the LAN LEDs should be ON (provided the
PC is also ON.)
• The WLAN LED should be ON
• The ADSL LED should be ON if ADSL line is connected.
Configuration
The ADW-4302 contains a HTTP server. This enables you to connect to it, and configure it,
using your Web Browser. Your Browser must support JavaScript.
The configuration program has been tested on the following browsers:
• Netscape V4.08 or later
• Netscape 7
