Intellicharging and Discharging the Battery
The battery has been partially charged after production. It is recommended that the battery be
fully recharged before use.
1) Plug the CHARGER JACK on the CHARGER into the charger port on the side of the battery.
2) Plug the CHARGER into a wall outlet. The BATTERY INDICATOR LED lights up green
indicating the unit is charging. Charge the battery for approximately 12 hours or until
BATTERY INDICATOR LED is blinking green indicating the battery is fully charged.
Note:
The main POWER SWITCH on the top of the battery can be in either the on or off
position during charging.
3) The Intellicharger feature allows you to leave the battery plugged in full time. The battery
charges fully and shuts off when full charge is achieved. Intellicharger then keeps your
battery fully "topped-off" by "pulse" charging the battery for a few seconds each minute to
maintain a full charge without risking battery damage. Very Smart!
WARNINGS AND PRECAUTIONS:
* The Intellicharger charges approximately 12 hours before reverting to "pulse" charging. Any
disruption of power to the Intellicharger will reset the charging cycle.
* The recharging unit is for indoor use only and is designed only for use with this lighting system.
* The battery and the charger will become warm during charging. If either becomes too hot to
touch, discontinue charging and contact your dealer.
* Disconnect the battery cable from the light head during non use to avoid accidental light
activation and possible fire hazard from heat of the bulb.
* The water bottle battery is a sealed unit. Do not attempt to open the bottle cap as it can
damage the unit and voids the warranty.
* To ensure maximum run-time, make sure your battery is fully charged before use.
* If the battery is not used for a long period of time, charge it once every three months to
maintain the life of the Nickel Metal Hydride (NiMH) battery.
* During long periods of non-use, unplug the charger from the battery pack.
OPEN
CLOSED
POWER PLUG
BRACKET CLAMP
CABLE
QUICK RELEASE LEVER
REMOTE SWITCH
Operating the Light
1) Turn on the battery POWER SWITCH on top of the water bottle battery. The POWER LED will
light up red when the power is on. After switching the power on, the headlamp will be
illuminated for the first 3 seconds while the system checks the current power reserve.
2) To turn the light on, press and hold the REMOTE SWITCH for 1-2 seconds.
3) To change power settings, press and release the REMOTE SWITCH. The switch will change
from low to medium to high and back to low power with each click of the REMOTE SWITCH.
4) To turn the light off, press and hold the REMOTE SWITCH for 1-2 seconds. Press the battery
POWER SWITCH to the off position.
WARNING:
When the BATTERY INDICATOR LED lights red, this indicates the battery is getting
low. You will have approximately 15-20 minutes of run time remaining. During this time, the
system will automatically change to "reserve power" in the 9 watt power setting.
Note:
If the battery POWER SWITCH is not turned off during non-use, the battery will continue to
use power and will go dead over a period of several days.
Mounting Instructions
1) Wrap BRACKET CLAMP around the handlebar as shown.
2) Adjust QUICK RELEASE clamp tension on the bar by rotating the LEVER clockwise to tighten
or counterclockwise to loosen.
3) Close CLAMP LEVER to secure. Ideal tension allows for the light beam to be adjusted up or
down by pushing the light case with your hand.
4) Insert POWER CORD PLUG into light case receptacle and battery pack.
5) Insert BATTERY PACK into forward water bottle cage.
*Side to side beam adjustment is adjusted by loosening the screw on the bottom of the light case.
POWER LED
POWER
SWITCH
BATTERY
PACK
BATTERY INDICATOR LED
CHARGER
CHARGER
JACK
RECHARGEABLE BATTERY PACK
C D
