TC160M1
User Manual
(v1.3)
www.planckvisionsystems.com
3
3
Initial Setup
Steps shown in Figure 3 may be followed for the initial setup of the ThermaCheck M1 camera. The camera head
mounts to a 1/4-20" threaded screw (a standard for camera tripods). Typical mounting hardware for the
ThermaCheck M1 camera is shown in Section 7.
Steps: 1) Mount the camera in a suitable screening location. Please see Section 6 for additional screening location
requirements.
2) Connect camera head to power adaptor through the red 12V connector on the camera’s rear pig-tail.
3) Connect power adapter to the wall outlet.
4) Connect camera head to a display (not provided) using the HDMI cable provided.
5) Connect provided mouse to camera head through the USB connector on the camera’s rear pig-tail. The
mouse need only be connected to the camera while changing settings though the UI. During normal
screening operation, the mouse may be disconnected.
Figure 3: Schematic of the ThermaCheck M1 initial setup.
Notes:
1)
Camera should be mounted so that screening subjects are 1-4m from the camera.
2)
ThermaCheck M1 camera has many real ports to enable integration with access control systems. Please
contact
for additional information.
