Planar User’s Manual
ii
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set
out in the Radio Interference Regulation of the Canadian Department of Communications.
“Le présent appareil numérique n’èmet pas de bruits radioélectriques dépassant les limites applicables aux appa-
reils numériques de la class B prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère
des Communications du Canada”
Important Safety Instructions
Please read the following instructions carefully. This manual should be retained for future use.
1.
To clean your New Planar LCD Monitor screen, first, make sure the Monitor is in the power off mode. Un-
plug the Monitor from its power source before cleaning it. Do not spray liquid cleaners directly onto the unit.
Stand away from your New Planar LCD Monitor and spray cleaning solution onto a rag. Without applying
excessive pressure, clean the screen with the slightly dampened rag.
2.
Do not place your New Planar LCD Monitor near a window. Exposing the Monitor to rain, water, moisture
or sunlight can severely damage it.
3.
Do not place anything on top of the Monitor-to-PC signal cord. Make sure the cord is placed in an area
where it will not be stepped on.
4.
Do not apply pressure to the LCD screen. Excessive pressure may cause permanent damage to the display.
5.
Do not remove the cover or attempt to service this unit by yourself. You may void the warranty. Only an au-
thorized technician should perform servicing.
6.
Safe storage of your New Planar LCD Monitor is in a range of minus 20 to plus 65 degrees Celsius (68°F-
149°F). Storing your New Planar LCD Monitor outside this range could result in permanent damage.
7.
If any of the following occurs, immediately unplug your Monitor and call an authorized technician.
•
The power or Monitor-to-PC signal cord is frayed or damaged.
•
Liquid has been spilled onto the Monitor, or it has been exposed to rain.
•
The Monitor has been dropped or the case has been damaged.
8.
The appliance should be disconnected from the mains by pulling the mains power cord/mains plug.
9.
The socket-outlet shall be installed near the equipment and shall be easily accessible.
