7
If the Temperature Control mode is selected (regardless
of activation of the Ventilation mode), then the required
value of temperature is set by pressing the buttons
(decrease) or
(increase)
(in the range from 1 to 30ºС in the zone of the selected
sensor).
There is no need to confirm the setpoint for heat or temperature.
Depressing
switches off the heater.
To switch off the heater, press the button
. This terminates fuel supply and the
combustion chamber is purged for 3-5 minutes. The LED indicating the operating mode will
flash rapidly until the end of the purge.
The heater power shall NOT be disconnected until the end of the
purging cycle
To save energy, a light indicator turns off in 20 seconds after the last
press of any button. To resume display press any button.
In case of open-circuit failure of the cabin temperature sensor (during
operation), the heater will go to medium-power level.
Troubleshooting
.
Faults that occur during heater operation, are coded and automatically indicated on the
Controller display. The fault code and the operating mode LED will blink slowly
ATTENTION
Maintenance and repairs should be carried out by trained qualified
personnel only!
You can eliminate the following faults yourself (see Table 1).
With all other faults, or if you cannot self-troubleshoot the problem, please contact a
service center.
