Planar PS7050, User Manual

Page: 18 / 42

Locking the Remote
18 PS7050/PS7050T and PS8250/PS8250T User Guide
Locking the Remote
To lock and unlock the remote control, hold the F1 button down for 10 seconds.
IR Sensor and LED Indicators
The IR sensor is located on the bottom right side of the front bezel. To operate the
remote control, point the remote directly at the IR sensor. Make sure the batteries are
installed in the remote before operation.
The LED indicator light is located in the IR sensor window. The following table
explains the condition for each of the indicators.
Using the Display in Portrait Mode
When looking at the rear of the display in landscape orientation, rotate the display
counter-clockwise for portrait orientation. This will allow for proper ventilation. The
directional indicator is located on the bottom of the product rating label for
reference.
Caution:
Improper ventilation may shorten the life of the display.
Using the Display in Flat or Tilted Orientation
The display is not recommended for use in flat orientation for tabletop, floor, or
ceiling installations. LCD panels of this size are at risk of panel deflection, which can
cause cosmetic sagging, brightness uniformity issues, a shortened life span, and
malfunction of optional touch sensors. Installations where the display is tilted
downward or upward at an angle may also be prone to these issues and are not
recommended.
Turning the Display On
1 Insert the power cord into the display and the power outlet.
2 Press the power button on the remote or keypad.
LED Status Condition
Green Display turned on but no input detected
Red Display turned off
Off Display turned on and input detected