Planar Bobcat X SN-4045-WX, User Manual, Page: 86 / 157

79
If RS232 communication does not work
See “Basic RS232 Troubleshooting” on page 143.
Unsure what’s wrong?
See “Reading the Status Menus” on page 81 and “Reading
the LEDs” on page 137.
Colors are wrong Input Levels must be adjusted For analog computer sources, see “Adjusting
Levels for Analog Sources” on page 31. For
digital computer sources, see “Adjusting Lev-
els for Digital Sources” on page 29
For further suggestions, see “Image Problems” on page 141
If your picture is visible, but something is wrong with it (Continued)
Symptom Possible Cause Explanation / Further Action
Bobcat X doesn’t respond to remote control
Possible Cause Possible Resolution
IR response disabled via RS232 Re-enable IR response using RS232 commands
Remote batteries are dead or improperly installed Replace or reinstall batteries
Remote was not aimed at the IR receiver The IR receiver is in the lower right corner (in landscape
mode; in portrait mode, it is in the lower left corner) of the
screen bezel behind a small hole
Something is blocking the IR receiver Remove the obstruction