Plamen International TEPMO, Installation And Operating Instructions Manual

Page: 19 / 60

Installation instructions
When installing the cooker, make sure that relevant local, national and European
regulations are fully complied with.
After having unpacked the cooker, inspect it carefully for possible damages in transport.
Any such damages should be immediately reported, because late claims will not be taken into
consideration. To install the cover, insert the hinge pins into the respective guides on the top
plate. In the log drawer, you will find the following accessories: a cleaning shovel, a poker and a
protective glove with PLAMEN logo. In the log drawer you will also find a
g allery that should be
installed on the top plate frame as shown in the Figure 1.
Install the flue collar in its position making sure that the connection between the cooker
and chimney is firm and tight. The cooker is connected to the chimney with a standard flue pipe
dia. 120 mm. The flue pipes should have adequate rise at all points. Do not connect the cooker
to a chimney to which another appliance has already been connected. Prior to connecting the
cooker to the chimney, make sure that the chimney is free from any cracks and / or other
damages. The cooker should be installed in a room with sufficient supply of fresh air to support
the combustion. If an exhauster (hood) or similar air-consuming unit is installed in the same
room, regular supply of fresh air should be provided through a separate opening, protected with
a non-clogging grid.
Make sure that the cooker is installed in a place allowing easy access for flue and chimney
cleaning operations.
Make sure that there are no combustibles in the immediate vicinity of the cooker. The
cooker may be installed only in a room where there is no risk of fire or explosion.
Minimum clearances between the cooker and combustibles, such as wood, chipboard,
corkboard, etc. should be strictly observed, in particular 800 mm in front of the cooker and 150
mm in other directions. In case of highly flammable materials, such as PVC, polyurethane,
pressed wood fibreboards, etc. or materials of unknown flammability, these clearances should
be doubled.
If the cooker is to be installed in a room with combustible or heat sensitive flooring, it shall
be placed on a solid, non-combustible floor protector. The floor protector must be dimensioned
to extend at least 800 mm to the front of the cooker and 150 mm to other directions.
Figure 1
19