~ 53 ~
CAUTION!
1. The condenser and the compressor, located at the rear of the
appliance, can reach high temperatures during ordinary operation.
Carry out the installation according to this manual. An insufficient
ventilation of the appliance will impair its operation and will damage
the appliance. Do not cover or block the ventilation slats at any time.
2. Do not touch extremely cooled surfaces with wet or damp hands,
because your skin may stick on these surfaces.
3. Always ensure that your fingers are not between the door and the
housing of the appliance while closing the door. RISK OF
CRUSHING!
NOTICE!
1. Do not store dry ice in the appliance.
2. When you move the appliance, hold it at its base and lift it carefully.
Keep the appliance in an upright position.
3. When you move the appliance using the rollers (depending on
model), only move it forwards or backwards as the rollers are not
pivotable and do not allow any lateral motion. Lateral motion can
damage the appliance and floor seriously.
4.
Do not tilt the appliance more than 45°.
5.
If the appliance is transported in a horizontal position, some oil may
flow from the compressor into the refrigerant circuit.
6.
Leave the appliance in an upright position for
4 - 6 hours
before you
switch it on to ensure, that the oil has flowed back into the
compressor.
7.
If you use the appliance for the first time or the appliance has been
disconnected from the mains for a longer period of time, allow the
appliance to cool down for 3 until 4 hours on medium temperature
setting
before
you place any fresh food in the appliance. If you place
food in the appliance before it has reached its normal operating
temperature, the food can spoil.
8. Never use the door for moving the appliance as you will damage the
hinges.
9. The appliance must be transported and installed by at least
two
persons
.
10.
When you unpack the appliance, you should take note of the position
of every part of the interior accessories in case you have to repack
and transport it at a later point of time.
11. Do not operate the appliance unless all components are installed
properly.