
70
Load: 9 place settings, lower rack in low position, rinse aid setting 5 (or 4 when
dispenser has 4 levels).
6.1 Starting of a programme
1.
Fill the lower rack first.
2.
Pour the dishwasher detergent and the water softener (=dishwasher salt) in the
relevant containers.
3.
During operation the appliance must be supplied with water (full water
pressure).
4.
Close the door properly while pressing gently. When the door closes properly
you will hear a light KLICK.
5.
Press the PROGRAM button to select a programme.
6.
Press the OFF button when the programme has ended. Open the door.
6.2 How to change a running programme
You can only change a programme when it has run a short period of time.
Otherwise the detergent has dissolved and the dishwater has been
drained. In such a case you must refill the detergent container.
1.
Open the door and press the current programme selection for at least 3
seconds.
2.
Set the new programme.
3.
Close the door.
When you open the door while the appliance is operating, the appliance will stop
operating. The display indicates the code E1. When you close the door again, the
appliance will start operating after 10 seconds.
The 6 control lights indicate the status of the appliance.
a)
One light is on = the relevant programme is running.
b)
One light flashes = Pause - mode.
NOTICE!
If all lights begin to glimmer, the appliance has a malfunction
and cannot be operated any longer. Disconnect the appliance from the
mains and stop the water supply, before you call the aftersales service.