Pixsys ATR 902, User Manual

Page: 21 / 32

User manual - ATR902 - 21
8
c. HY.
Command Hysteresis
Hysteresis in ON/OFF or dead band in P.I.D. for command output.
-99.9…+99.9 tenths of degree.>
Default
: 1.0.
9
P.b.
Proportional Band
Process inertia in degrees.
0.0 ON/OFF if also
t.i.
equal to 0. > Default .
0.1…999.9 tenths of degree.
10
t.i.
Integral Time
Process inertia in seconds.
0.0…999.9 seconds. Integral 0 disabled. > Default : 0.0.
11
t.d.
Derivative Time
Normally ¼ of integral time.
0.0…999.9 seconds. Derivative 0 disabled. > Default : 0.0.
12
t.c.
Cycle Time
Cycle time (for P.I.D. on contactor 10”/15”, for P.I.D. on SSR 1”)
1…300 seconds. > Default : 10.
13
c. s.e.
Command State Error
SContact status for command output in case of error.
o.c.
Open Contact > Default
c.c.
Closed Contact
14
ui.d.2
Visualization Display 2
Set visualization on display 2 during a cycle
e.st.s.
(End Step Setpoint) End temperature of operating step
r.spu
(Real Setpoint) Updated according to the selected gradient
cy.nu.
(Cycle Number) Number of operating cycle. > Default
st.nu.
(Step Number) Number of operating step
time
Time elaplsed from cycle start
15
de.st.
Delayed Start
Enables initial waiting for delayed start of cycle
dis.
(Disabled) Initial waiting disabled. > Default
en.
(Enabled) Initial waiting selectable by the user.