iii
PixeLINK PL-A780
Document No.: 04646-01
MACHINE VISION CAMERA
SYSTEM GUIDE
Copyright © 2004 PixeLINK
All Rights Reserved
Federal Communications Commission (FCC) Statement
FCC testing will be completed in 2004. All units shipped prior to the completion of FCC testing should be considered as prototypes
and will be marked with the statement that the FCC rating is pending. Note that the PL-A780 Series is materially similar to the PL-
A780 which has passed FCC and CE compliance testing.
When tested, the equipment will be measured against the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. Operation is
subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
o
Reorient or relocate the receiving antenna.
o
Increase the separation between the equipment and receiver.
o
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
o
Consult the dealer or an experienced radio/TV technician for help.
Properly shielded and grounded cables and connectors must be used to meet FCC emission limits. PixeLINK is not responsible for
any radio or television interference caused by using other than recommended cables or connectors.
Unauthorized changes or modifications to the equipment could void the user’s authority to operate the equipment.
European Community (CE) Statement
Testing for product safety compliance in the European Community will be completed in 2004. Units shipped prior to the completion
of the testing should be considered as prototypes and will be marked indicating that the CE rating is pending. When tested, the
product will be measured for compliance with the following directives and standards:
Directives:
2001/95/EC (General Product Safety Directive)—Self-declared 89/336/EEC (EMC Directive)
Standards to which conformity is declared:
EN55024: 1998
EN55022: 1998 For Class B
EN61000-3-2: 1995 EN61000-3-3: 1995
Manufacturer’s Name and Address: PixeLINK 3030 Conroy Road, Ottawa, Ontario, K1G 6C2, Canada
Type of Equipment:
PixeLINK FireWire Machine Vision Camera
Model Number:
PL-A782
