8
Rear Panel
11
10
9
8
7
6
5
4
3
2
1
No.
Name
Description
1
DC 12V
Connect this port to a 12 V 1 A power adapter.
2
Reset
Use this button to reset device.
When PF-IPEJ100F is powered on, use a pointed stylus
to hold down this button for five or more seconds, and
then release it, it will reboot and restore to its factory
defaults.
3
LAN (PoE)
Connect either the copper port or fiber* port to a gigabit
Ethernet switch for outputting IP stream, controlling
device and receiving power (the unit can be powered by
a PoE-enabled switch).
Default Protocol
Default IP Mode
Auto IP
IP Address
169.254.x.x
Subnet mask
255.255.0.0
Note:
1) *Connect the fiber port to the Ethernet switch using
a single-mode or multi-mode SFP module (not
included in package). The transmission distance
may vary depending on the specific SFP module
used.
2) DO NOT connect both the copper port and fiber
port to the Ethernet switch simultaneously,
otherwise device exceptions may occur.
4
Audio In
Connect this 3.5 mm stereo tip-ring-sleeve port to an
audio source such as a computer for unbalanced stereo
audio signal input.
Note:
When this audio port is connected to an audio source,
both encoder and decoder will output the audio signal from the
audio source instead of that from the HDMI video source. If this
audio port is connected via an audio cable but no audio signals
are input, you can get picture but no sound. The situations above
do not apply to the HDMI loop-through port in encoder, which can
still output the AV signals from the video source.
5
Audio Out
Connect this 3.5 mm stereo tip-ring-sleeve port to an
