Using the Trigger Set
■
Wireless Adjusting Flash Settings
The trigger set can wireless adjust the following settings: the
flash power ratio, the on-or-off of the buzzer and the modeling
lamp or the AF-assist beam, as well as the power-ratio display
mode.
1. On the transmitter and the receiver, set the Channel Select
Switch to the same position and the Power-Control Group
Select Dial to the same grade.
2. Insert the receiver into the Wireless Control Port of the flash
unit. Then power the flash on.
3. Adjust the flash settings on your transmitter.
■
Wireless Triggering the Flash
1. On the transmitter and the receiver, set the Channel Select
Switch to the same position.
2. Insert the receiver into the Wireless Control Port of the flash
unit. Then power the flash on.
3. Press the Test Button to fire a flash. Alternatively, you can
set the transmitter onto the camera's hot shoe and press the
camera's shutter-release button to fire a flash.
Proper
Improper
Other Buttons
1. Set Button (
SET
)
Press the Set button and settings on the transmitter will be
communicated with the flash through the receiver. Will
blink for sec. on the LCD display.
Press and hold the Set button for 2 sec. to switch the power-
ratio display mode.
2. Buzz Switch (
BUZZ
)
Press the Buzz Switch to turn the buzzer on or off. When the
buzzer is turned on, will be shown on the LCD display.
3. Modeling Lamp Switch / AF-Assist Beam Switch (
LAMP
)
Press the switch to turn the modeling lamp or AF-assist
beam on or off. When the lamp or beam is turned on, will
be shown on the LCD display.
4. <
-
><
+
> Button
Press the <
-
> or <
+
> button to decrease or increase the
power ratio. The power range is “OF, 5.0~10” or “OF,
1.0~7.0”
for studio flashes and “OF, 1/128~1/1” for shoe
mount flashes. “OF” means the flash triggering function is
shut down on the flash.
To disable the flash triggering of a flash group, press “ - ” and
“+” buttons at the same time, with the panel displaying “OF”.
5. Test Button (
TEST
)
Press Test Button to fire the flash. Both the indicators on the
transmitter and the receiver will blink.
Connect/Disconnect
PRO ST-I
Disconnection Way
Connection
1. The Dial of the transmitter and the receiver must be set to
the same grade. Otherwise, the receiver does not respond.
2. Flash triggering is only related with Channel Select Switch.
The Power-Control Group Select Dial only decides which flash
or flash group to be controlled in terms of functions such as
power setting.
