1-ALT
2-ALT
OFF
1,2
STEP
1.0-10
Display in the form of decimal
1/512-1/1
Display in the form of fraction
MULTI
OFF
Off Multi Flash
ON
On Multi Flash
RECYCLE
STD
Within 4 seconds in 110V
standard recycling mode, within
2 seconds in 220V standard
recycling mode
MAX
Within 2 seconds in 110V fastest
recycling mode, within 1 second
in 220V fastest recycling mode,
and fastest up to 0.7s
LANGUAGE
ENGLISH
Chinese(Simplified)
RESET
NO
YES
Reset to default
TIMES
16976
Record flash times
UNITES
2 MASK
3 ALT
4 ALT
DELAY
OFF
0.01~30s
Off
Can be set as
second-curtain sync
The system provides real-time protection to secure the device and your
safety. The following lists prompts for your reference:
2. Other Protections
Prompts on LCD Panel
Meaning
E1
A failure occurs on the recycling system so that the flash cannot fire.
Please restart the flash unit. If the problem still exists, please send this
product to a maintenance center.
E6
Flash fan failure
E3
The voltage on two outlets of the flash tube is too high. Please
send this product to a maintenance center.
E9
There are some errors occurred during the upgrading process. Please
using the correct firmware upgrades method.
Protection Function
For full instructions on the use of flash trigger, see its user manual.
1. Over-Temperature Protection
The inner over-temperature protection function may be activated when
firing more than 200 continuous flashes in fast succession at 1/1 full
power and
< >
will be displayed. If gets a slower recycle time in firing,
please allow a rest time of about 5 minutes, and the flash unit will then
return to normal and the
< >
will disappear.
19
20
camera hot shoe. Settings made on the hotshoe-mounted transmit and
receive ends will be wirelessly communicated to the flash. Then you can
press the camera shutter release button to trigger the flash. You can also
hold the transmit end at hand to control your off-camera flash.The Sync
Cord Jack is a Φ3.5mm plug. Insert a trigger plug here and the flash will
be fired synchronously with the camera shutter.
The Sync Cord Jack is a Φ3.5mm plug. Insert a trigger plug here and the
flash will be fired synchronously with the camera shutter. To control the
flash wirelessly, you need to insert the receive end of flash trigger into
the Wireless Control Port on the flash and insert the transmit end into the
Sync Triggering
