10
Using the SlimFire Remote Control KeyFob
Your RF wireless remote control unit is used to power up your
UndercoverEye™ Trekker MiniDVR via a wireless command by
pressing the buttons on the remote control.
By pressing the “On” button, note there are 2 sets of “On” and
“Off” buttons which are redundant. This will power up the
camcorder and start it recording. By pressing the “Off” button the
camcorder will stop recording and power down the camcorder.
Your RF wireless remote control can control your
UndercoverEye™ Trekker MiniDVR from a distance up to about
180 feet “line of sight”. For best reception be sure to have a clear
view of the Remote VideoEye™ from your controlling location.
RF Wireless Remote Control
KeyFob
Introduction to the Wireless PIR Motion Sensor
The PixController DigitalEye RF (Radio Frequency) is a
wireless camera controller which works in conjunction with the
wireless PIR motion sensor. The PixController RF boards
"listens" for wireless commands sent from the wireless PIR
motion sensor when the motion sensor is tripped. When the
RF board receives a trigger event it will trigger the attached
camera or camcorder to take a photo or record video.
There are 2 AAA batteries that power the motion sensor
which will last for a year of continuous use. To replace them
just remove the battery door.
Never touch the PIR lens as this could damage the PIR
sensor
Setting Wireless PIR Motion Sensor Addresses
Each wireless PIR sensor can be setup to send out a unique address. Wireless PIR sensors are
assigned an 'address', which consists of addresses between “A” to “P.
To change the Address that the Wireless PIR transmits:
First, remote the 4 screws from the back of the case and
take off the cover as shown.
Press and hold the
Address
button (under the battery compartment lid) the red LED
flashes first and then blinks the current setting (once for
A, twice for B, etc.). Release and immediately press the
button the desired number of times for the House Code
you want to set (once for A, twice for B, etc.) and
hold
the button on the last press
. 3 seconds after the last
press (while holding the button) the red LED blinks back
the number of times for the code you set. Release the
button.
