www.pivotcycles.com
1.877.857.4868
9
SHIMANO STEPS E-BIKE SYSTEM
1. Check the orientation of the battery before
installing the battery.
2. Carefully route the battery through the fork
stanchions and into the downtube.
3. Apply downward pressure on the battery to fully
seat the battery into the terminal block
4. Rest the front of the battery on the bracket
attached to the cover and align the back of the
cover with the edge of the battery cavity. Lift the
the front of the cover into place.
5. Grease the pins and install them to the frame
(starting with the forward pin) while apply
pressure to the battery cover. The pins are
different lengths. The shorter pin is installed in
the front and the longer pin is installed in the
back.
6. Torque the pins to 10 Nm.
Removing the Battery
• The battery may need to be removed to swap batteries or to charge the battery if there is no power supply
near the bike.
• This procedure may be easier with the bike upside down.
1. Using a M5 hex wrench, remove the two pins
securing the battery cover to the frame.
2. Remove the cover from the frame. The battery will
remain in the frame after the cover is removed.
3. Slowly apply forward pressure to unseat the
battery from the terminal block located inside
the downtube. CAUTION: The amount of force
required may cause the battery to move forward
quickly once it disconnects from the terminal
block.
4. Reach through the fork stanchions and carefully
pull the battery through the fork to remove the
battery. The battery is heavy and this action may
require two hands.
1
5
2
3
4
Installing the Battery
• To install the battery, reverse the removal procedure from above
1
2
3
4
6
5
(10 Nm)
5
LONG
SHORT
