Page 9
For technical questions, please call 1-888-866-5797.
Item 60395
S
AFET
y
O
PERA
TION
M
AINTENAN
c
E
A
SSEM
b
Ly
Maintenance and Servicing
Procedures not specifically explained in this manual must be performed only by a qualified technician.
TO PREVENT SERIOUS INJURy FROM AccIDENTAL OPERATION: Do not use damaged equipment.
If abnormal noise or vibration occurs, have the problem corrected before further use.
cleaning, Maintenance, and Lubrication
1.
before each use,
inspect the general condition
of the Jack. Check for broken, cracked, or
bent parts, loose or missing parts, and any
condition that may affect the proper operation
of the product. If a problem occurs, have the
problem corrected before further use.
Do not use damaged equipment.
2.
before each use, thoroughly test the Jack
for proper operation prior to its actual use.
If the Jack appears
not
to be working properly,
follow
Bleeding
instructions on facing page.
3.
change the hydraulic oil at least
once every three years:
a. With the Jack unfolded and fully lowered, remove
the Oil Filler Plug on the side of the Housing.
b. Tip the Jack to allow the old hydraulic oil
to drain out of the Housing completely,
and dispose of the old hydraulic oil in
accordance with local regulations.
c. With the Jack upright, completely fill the Housing
with a high quality hydraulic oil (not included) until
the oil just begins to run out of the Oil Fill Hole.
d. Then, reinstall the Oil Filler Plug.
4. Clean with a clean cloth with a detergent or
mild solvent. Then, store the Jack in a safe,
dry location out of reach of children
.
Troubleshooting
TO PREVENT SERIOUS INJURy: Use caution when troubleshooting a malfunctioning jack.
Stay well clear of the supported load. completely resolve all problems before use.
If the solutions presented in the Troubleshooting guide do not solve the problem, have a qualified technician
inspect and repair the jack before use.
After the jack is repaired: Test it carefully without a load by raising it
and lowering it fully, checking for proper operation, bEFORE RETURNING THE JAcK TO OPERATION.
DO NOT USE A DAMAGED OR MALFUNcTIONING JAcK!
POSSIbLE SyMPTOMS
PRObAbLE SOLUTION
(Make certain that the jack is not supporting
a load while attempting a solution.)
Jack will
not lift at
its weight
capacity
Saddle
lowers
under
load
Pump
stroke
feels
spongy
Saddle
will not
lift all the
way
Handle
moves up
when jack
is under
load
Oil
leaking
from filler
plug
X
X
Check that Release Pedal is not
stuck and raises completely.
X
X
X
Valves may be blocked and may not close fully.
To flush the valves, with assistance:
1. Lower the Lift Arm and release the Release Pedal.
2. Manually lift the Lift Arm several inches.
3. Press the Release Pedal and force
the Lift Arm down quickly.
X
X
X
Ram may be low on oil. Check the
oil level and refill if needed.
Ram may require bleeding - see facing page.
X
Unit may have too much hydraulic oil inside.
Check fluid level and adjust if needed.
