Tear-Down Instructions
1. When ready to disassemble the arena, it is recommended to
reverse the setup process. After the arena is totally empty,
remove the bungee cord ties from the netting. Start with the
lower cords and progress to the upper levels, leaving the top four
corners and sides attached.
2. Remove the bungee cord ties from two short corners and
proceed to remove remaining cords to the other end. Bring
the four corner pieces to the center of the netting and use one
bungee cord tie to tie them together.
3. Fold the netting and place back in box.
4. Using a ladder, start at the top and take all the pipes and
connectors apart and place them back in their boxes. Note: If
some connections have become too tight to remove by hand,
use a rubber mallet to tap them apart. Do not use any tools with
hard surfaces as this might damage or break your framing pieces.
Drone Arena User Guide
10
