ENGLISH
10
9. INSTALLING THE COOKING GRIDS
Parts Required:
2 x Cooking Grids (#2)
1 x Upper Cooking Rack (#1)
• Place the cooking grids, side-by-side, on the grid ledge inside the main grill.
NOTE: To maintain the searing and grilling performance of your
cooking grids, regular care and maintenance Is required.
10. PLACING THE GREASE BUCKET
Parts Required:
1 x Grease Bucket (#13)
Installation:
• Place the grease bucket on the spout hook on the end of the main
barrel. Ensure it is level to avoid grease spills.
• The unit is now completely assembled.
11. CONNECTING TO A POWER SOURCE
NOTE: Before plugging your Pit Boss® into any electrical outlet,
ensure the Temperature Control Dial is in the SMOKE position.
• STANDARD OUTLET
This appliance requires 110-120 Volt, 60 Hz, 250 W. It must be a 3-prong
grounded plug. Ensure grounded end is not broken off before use. The
control uses a 110-120 volt, fast-blow fuse to protect the board from the
igniter.
• GFCI OUTLETS
This appliance will work on most GFCI outlets, with a recommended
size of 15 amp service. If your GFCI outlet is highly sensitive to power
surges, it will likely trip during the start-up phase of operation. During
the start-up phase, the igniter draws 200-700 watts of electricity,
which can be too much power for a GFCI outlet to handle. Each time it
trips, it increases in sensitivity. If the GFCI keeps tripping, replace the
outlet or change to a non-GFCI outlet.
• ON THE ROAD
Disconnect the igniter from the main wiring harness. Use the manual
start-up procedure. A Pit Boss® unit can operate using a 12 volt,
100 watt inverter plugged into your automobile outlet. To use the
automatic igniter, it is recommended to use a minimum of a 1000 watt
inverter.
IMPORTANT: Disconnect unit from power source when not in use.
11
FAST-BLOW FUSE,
5 AMP
10
9
