Add Contact Phone Numbers
Press
PROGRAM
key on console. Enter the default password
888
888
. Use
scroll key
to select
Phone
Numbers
, press
Enter
, you will see below list
Add
select Add press
Enter
. You will see Input phone number, than direct input your area code and phone
number. And save it. You can add maximum of 6 numbers for emergency contact if the system is triggered.
It is recommend to add your cell phone and your family or friends’ numbers. DO NOT add 911 or the local
police number directly unless you get a permit.
Delete
Select Delete then press Enter, you will see all numbers which you saved, choose the target number which
you want to delete then press Enter and delete it.
Outgoing Message
Press
PROGRAM
key on console and enter the default password 888 888. Use scroll key to select
Outgoing
Messages
, press
Enter,
you will see below list
Record
Voice
Message
press
Enter
, select
Record
, press
Enter
. You will see
“Recording”
and a counter from
10 to 00. When you see
10
, you need to immediately start recording your voice and stop when you see
00
. It
is recommended that you record your home address for the outgoing message.
Play
You can select Play to play your voice. If you do not like it, you can Delete it and Record it again until you are
satisfied.
Note
: The closer you are to the console during recording, the better the quality of the recording. Your mouth
should be no more than
2 inches
away from the console.
Connect Monitoring Center
Press
PROGRAM
key on console. Enter the default password 888 888. Use scroll key to select
Monitoring
Center
. You can call your Monitoring Company to set up all requests. Please make sure your monitoring
company supports ADMECO protocol if you want a third party Monitoring Company to monitor your system (
it will
cost you a monthly monitoring charges depending on which company you choose.
)
Monitoring Center Number
press Enter then select
Add
to add your monitoring center telephone number
ADMECO Contact Id
press Enter then select
Add
to add your monitoring company 4 digits
account number
.
Select
Delete
to delete your account number, select
ADEMECO Contact ID
then press Enter to select the
protocol ID according your monitoring center protocol ID request.
Upload Alarm Data
press Enter if set YES, all your data will be upload to monitoring station, default is NO.
Upload Arm/Disarm Data
press Enter if you set YES, every time you do arm or disarm your system
information will be upload to monitoring station, default is NO.
