12
6
9
12
6
9
8
TROUBLESHOOTING
The Piraya shuts down incorrectly
The Piraya is not in the water......................
The floating cable connector is unplugged.
The pump wheel is blocked.........................
Phase sequence is wrong..........................
Linerpool.....................................................
Put it down in the water
Insert floating cable plug
See page 6, No. 6
See page 7, No. 1-2
See page 9
Does not manage to auto-turn
Litter in the brush mounts...........................
Too low drive power...................................
Linerpool.....................................................
See page 5, No. 4
See page 9
See page 9
Runs a short distance and then auto-turns
Program 2 is selected..................................
5th LED does not blink when driving.........
Linerpool.....................................................
If the problem persists............................. Contact Piraya service
Select program 1
Check small wheel
See page 9
Deviates from the course in a rectangular pool
The drive wheels are worn/slippery............
Floating cable is twisted.............................
Wheels must be replaced
Straighten it out
Program 1 does not get carried out properly
Too high drive power..................................
The Piraya is started at wrong location......
Program 2 is selected.................................
See page 9
See page 3
Select program 1
LED:s indicate
1. Power to the left drive wheel is on
2. Power to the right drive wheel is on
3. Forward drive is on
Stop Mode
4. Reverse drive is on
5. Flashes when driving
6. Pump current is too high
(Lit only for 5 seconds)
Advanced settings
Adjustment for drive power
Adjustment for auto-turning
(Use a small screwdriver
Never turn past 12 or 6)
