INSTRUCTION MANUAL
Widening the rest
Straightening the hinge joint of the shoulder leg by
bringing it outwards will widen the rest and create a
weaker clamping action (see picture
5
). In order to adjust
the hinge joint, loosen the Torx screw enough to allow
the joint to move. Move it to the desired position and
tighten the Torx screw.
A similar adjustment needs to be made to the chest leg
(see picture
6
). To make the rest wider, loosen the Torx
flange screw and slightly rotate the base joint anticlockwise.
After tightening the Torx flange screw, loosen the hinge
joint. Hold the rest down on a table with the feet parallel
to each other and all four hooks of the rubber feet tou-
ching the surface. Fix the resulting angle by tightening
the Torx screw.
Adjusting the tilt of the rest
The tilt of the rest can be adjusted as seen in picture
7
. In
order to increase or decrease the tilt of the rest, start with
the shoulder leg. Loosen only the Torx flange screw and
slightly rotate the whole leg clockwise to increase the tilt
or anticlockwise to decrease it. A small rotation will have
a noticeable e
ff
ect. After tightening the Torx flange screw,
loosen the hinge joint of the chest leg. Hold the rest down
on a table with the feet parallel to each other and all four
hooks of the rubber feet touching the surface. Fix the re-
sulting angle by tightening the Torx screw.
Returning the rest to
its original position
In its original position and when not attached to the
instrument (see page
10
picture
4
), the two hinge joints
of the rest lean slightly towards each other. This gives
the best grip on the instrument.
To return the rest to its original position first loosen all four
screws. Continuing with the shoulder leg, point the rubber
foot towards the centre of the rest as seen in picture
8
and
tighten the Torx flange screw. Now swivel the hinge joint
up to the angle seen in picture
4
and tighten the Torx screw.
Continuing with the chest leg, position this as seen in
picture
9
and tighten the Torx Flange screw. Hold the
rest down on a table with the feet parallel to each other
and all four hooks of the rubber feet touching the surface.
Fix the resulting angle by tightening the Torx screw.
Check once more that all screws are tight before playing.
12
EN
EN
13
7
Straight and angled tilt
8
Shoulder leg
9
Chest leg
