Ailerons & Flaps
Collect these parts:
ÿ
2 – Main Wings
ÿ
2 Ailerons
ÿ
2 Flaps
ÿ
4 – Servo Hatch Covers
ÿ
16 – Hatch Covers Screws
ÿ
4 Threaded Push Rods
ÿ
2 Trumpet Bases
ÿ
2 Trumpet Washers
ÿ
2 Trumpet Screws
ÿ
2 Control Horns
ÿ
2 Clevises
ÿ
2 Aileron Servos (minimum 70 oz. torque)
and mounting hardware (such as Hitec HS645MG)
ÿ
2 Flap Servos (minimum 50 oz. torque) and mounting hardware
ÿ
2 18 inch Aileron Servo Extensions
The Ailerons and Flaps have been predrilled and the Hinge Pins installed but not glued. Assure they fit and are
rotated so the Hinge Pin bends properly before using Epoxy glue.
Tip: To help keep glue out of the Hinge Pin joint, apply a small drop of light oil.
Find the openings in the bottom of both Wings for the
Aileron and Flap Servos and cut out the covering corner to
corner with an XActo Knife. Use a Heat Sealing Iron to
stick the covering to the edges, cutting off the excess
covering.
Use an XActo Knife to cut the covering for the Push Rods slots in
the 2 Aileron Hatch Covers. The Flap Hatch Covers have no slots.
Position the Aileron Hatch Covers so the Servo arm is on the wing
tip side and Control Surface side.
Page 5