Piper PA-28-161, Maintenance Manual

Page: 592 / 1104

PIPER AIRCRAFT, INC.
PA-28-161, WARRIOR III
MAINTENANCE MANUAL
PAGE 2
Nov 30/06
3I2
34-50-00
(2) Configuration Setup Procedure
Access the Configuration Mode of the unit by depressing and holding the ENT key while
applying power to the unit. Release the ENT key when the display activates. After the data
base pages, press the ENT key twice to display the MAIN ARINC 429 CONFIG page. Pages
may be selected by ensuring the cursor is off and rotating the inner concentric knob on the
right side of the unit.
To change data on the displayed Configuration Page, the cursor must be selected. Press the
inner concentric knob on the right side of the unit to activate the cursor. Rotating the outer
concentric knob on the right side of the unit changes the selected data field. Rotating the inner
concentric knob changes the data within the selected field. To accept entry of the desired
selection, press the ENT key.
(a) Main ARINC 429 Page
(PIR-PPS60199-2, Rev. I)
1 In S/N’s 2842001 and up, configure the MAIN ARINC 429 Page on both GNS #1 and
#2 as follows, for single GNS 430 installation use settings for GNS Unit #1:
SPEED DATA
IN 1 HIGH Garmin GTX 330
IN 2 HIGH OFF
OUT HIGH GAMA 429 GRAPHICS W/INT (GNS Unit #1)
OFF (GNS Unit #2)
SDI LNAV 1 (GNS Unit #1)
LNAV 2 (GNS Unit #2)
2 In S/N’s 2842218 and up, with Avidyne Entegra , configure the MAIN ARINC 429
Page on both GNS #1 and #2 as follows:
SPEED DATA
IN 1 LOW SANDEL EHSI
IN 2 HIGH GARMIN GTX 330
HIGH AIR DATA W/SKYWATCH
OUT LOW GAMA 429 GRAPHICS W/INT (GNS Unit #1)
SDI LNAV 1 (GNS Unit #1)
LNAV 2 (GNS Unit #2)