Piper Aircraft Corporation Malibu Mirage PA-46-350P, Airplane Maintenance Manual

Page: 879 / 1956

PAGE 3
Feb 28/07 4H5
33-40-00
PIPER AIRCRAFT, INC.
PA-46-350P, MALIBU MIRAGE
MAINTENANCE MANUAL
Position, Strobe, and Taxi Light Installation
Figure 1
(16) If ground wire was disconnected from plug bracket ground lug, connect this wire.
(17) Reconnect (P109 or P209) to plug bracket mate.
(18) Connect new three wire connector P-111 or P-211 and the original P-110 or P-210 connectors
to power supply.
(19) Install power supply to access panel with the eight AN960-10 washers and four attachment
screws.
(20) Install wing access panel with power supply attached and wires facing outboard, to the wing
surface with appropriate mounting screws previously removed.
(21) Install the light bracket assembly, lens, lens retainer and plexiglass cover.
D. Strobe Power Supplies Replacement
(1) Each wing tip strobe light is powered by its individual power supply which is attached to a wing
access panel located on the lower wing surface just inboard of the wing tip. Refer to Figure 2.
(2) Remove wing access panel.
(3) Unplug power supply connectors P-111 and P-110 on left wing and P-211 and P-210 on right
wing.
(4) Remove four screws and eight AN960-10 washers attaching power supply to wing access
panel and separate from power supply.
(5) Reverse procedures for installation of strobe power supply.