En
11
> Before start
> Hookup
> Setup
> Playback
> Part Names
1
2
1/2˝
(12 mm)
For high-
frequency
For low-
frequency
1
Speaker cable,
2
Subwoofer cable
in case of:
Page 8
Connect front speakers compatible with Bi-Amping
connection to the FRONT jacks and the SURROUND
BACK jacks. Make sure you remove the jumper bar fitted
between the woofer jacks and tweeter jacks of the front
speakers. In case of Bi-Amping connection, refer to the
instruction manual of your speakers. Up to two powered
subwoofers can be connected. The same signal is output
from each of the SUBWOOFER jacks.
Make sure the exposed wires of the speakers do not stick out of
the speaker terminals when connecting. If the exposed wires of
the speakers touch the rear panel or the + and – wires touch each
other, the protection circuit will be activated.
Setup
0
Bi-Amping connection requires you to change
some settings. Select "Yes" in "Bi-Amp" in "1. Full
Auto MCACC" ( P19) in the Initial Setup.
SN29402194_VSX-301_BAS_En.book 11 ページ ２０１６年１月６日 水曜日 午前１２時５分
