Controlling the rest of your system
10
61
En
Clearing all the remote
control settings
You can clear all presets and restore the
factory default settings.
1
Press REMOTE SETUP and hold for
three seconds.
The LCD display shows
SETUP
.
2
Press any MULTI CONTROL button.
3
Use
and
to select RESET then
press REMOTE SETUP.
The LCD shows
OK
when you’re done.
Direct function
• Default setting:
ON
You can use the direct function feature to
control one component using the remote
control while at the same time, using your
receiver to playback a different component.
This could let you, for example, use the
remote control to set up and listen to a CD on
the receiver and then use the remote control
to rewind a tape in your VCR while you
continue to listen to your CD player.
When direct function is on, any component
you select (using the
MULTI CONTROL
buttons ) will be selected by both the receiver
and the remote control. When you turn direct
function off, you can operate the remote
control without affecting the receiver.
1
Press REMOTE SETUP and hold for
three seconds.
The LCD display shows
SETUP
.
2
Press the MULTI CONTROL button for
the component you want to control.
3
Use
and
to select DIR SET then
press REMOTE SETUP.
The LCD on the remote displays the compo-
nent you want to control.
4
Use the number buttons to enter
either 9990 (direct on) or 9995 (direct off).
The LCD will display
OK
to show the four digit
code has been accepted.
• You can’t use direct function with the
TVC
function.
Confirming preset codes
Use this feature to check which preset code is
assigned to a
MULTI CONTROL
button.
1
Press REMOTE SETUP and hold for
three seconds.
The LCD display shows
SETUP
.
2
Press the MULTI CONTROL button of
the component for which you want to
check the preset code.
3
Use
and
to select READ ID then
press REMOTE SETUP.
The preset code appears in the display for two
seconds.
