Controls and displays
04
29
En
CH +/–
Use to select channels when using a TV, VCR, DVR,
etc.
These DVR controls can be accessed by pressing
SHIFT
:
REC
Starts recording.
REC STOP
Stops recording.
HDD/DVD
These buttons switch between the hard disk and DVD
controls for DVD/HDD recorders.
9
RECEIVER CONTROL buttons
THX
Press to select a Home THX listening mode
(page 31).
STANDARD
Press for Standard decoding and to switch between
the various Pro Logic IIx and Neo:6 options (page 30).
ADV. SURR
Use to switch between the various surround modes
(page 31).
STEREO
Switches between direct and stereo playback. Direct
playback bypasses the tone controls and any other
signal processing for the most accurate reproduction
of a source (page 32).
AUTO SURR
Press to have the receiver automatically detect what
kind of source you’re playing and select multichannel
or stereo playback as necessary (page 30).
ACOUSTIC EQ
Press to select an Acoustic Calibration EQ setting
(page 33).
SIGNAL SELECT
Use to select an input signal (page 33).
MIDNIGHT/LOUDNESS
Use Midnight when listening to movie soundtracks at
low volume. Use Loudness to boost the bass and
treble at low volume (page 36).
EFFECT/CH SEL
Press repeatedly to select a channel, then use –/+ to
adjust the level
(page 45). Also adjusts the level of the
Advanced Surround effects (page 31) as well as
Dolby Pro Logic IIx Music (page 32) and Neo:6 Music
parameters (page 32). You can then use the
+
and
–
buttons to make these adjustments.
+/–
Use to adjust the effect and channel levels, as well as
to change Dolby Pro Logic IIx and Neo:6 Music
parameter settings.
SLEEP (SHIFT & –)
Use to put the receiver in sleep mode and select the
amount of time before the receiver turns off
(page 37).
DIALOG E (SHIFT & +)
Use to make dialog stand out when watching TV or a
movie (page 36).
10 SHIFT
Press to access the DVR controls (above the component
control buttons) as well as some
RECEIVER
controls.
11
SOURCE
Press to turn on/off other components connected to the
receiver (see page 50 for more on this).
12 Character display (LCD)
This display shows information when transmitting
control signals.
The following commands are shown when you’re setting
the remote to control other components (see
Controlling
the rest of your system
on page 50):
SETUP
Indicates the setup mode, from which you choose the
options below.
PRESET
See
Selecting preset codes directly
on page 50.
LEARN
See
Programming signals from other remote controls
on page 51.
DIRECT F
See
Direct function
on page 52.
ERASE
See
Erasing one of the remote control button settings
on page 52.
RESET
See
Erasing all of the remote control presets
on
page 52.
READ ID
See
Confirming preset codes
on page 52.
13 RECEIVER
Switches the remote to control the receiver (used to
select the green commands above the number buttons
(
INPUT ATT
, etc). Also use this button to set up surround
sound (page 11, page 38).
14 VOL +/–
Use to set the listening volume.
15 MUTE
Mutes the sound or restores the sound if it has been
muted (adjusting the volume also restores the sound).
VSX_2014TX.book.fm 29 ページ
２００４年８月１８日 水曜日 午後２時３３分
