29
En
OPERA
TION
Playing Sources with Dolby Digital
Sound Modes
1
Follow steps 1 to 3 of the playback procedure. (Refer to
“Playback” on page 28.)
1
Turn on the power of the playback component.
2
Press AMP to turn on the amplifier.
3
Press FUNCTION to select the source component you want to
play.
2
Press AMP.
This sets the remote to select the sound mode.
(You can skip this step when using the controls on the amplifier.)
3
Press SIG.SELECT on the remote control or SIGNAL
SELECT on the front panel to select DIGITAL.
(Refer to “Switching ANALOG/DIGITAL signal input” on page 27.)
4
Press
to switch the Dolby Surround mode on.
Each press changes the Dolby Surround mode.
5
Start playback of the component you selected in step 1.
6
Press VOL (–/+) to adjust the volume level.
3
4
6
3
4
6
When playing LD recorded in Dolby Digital
When connecting a DVD/LD player or LD player using the AC-3 RF output, a commercially available RF demodulator
(RFD-1) is required. The RF demodulator changes the RF signal to a digital signal which is then processed by the
amplifier at the digital input jacks. For more details, refer to the instruction manual supplied with the RFD-1.
Refer to pages 42 for explanations of Dolby Digital, Dolby Pro Logic.
memo
1
1
1
2
DVD/LD
VCR 1
TV/SAT
CD
TUNER
VCR 2
MD/TAPE
TV CONTROL
AMP
DSP MODE
CH.SELECT
ATT
SIG.SELECT
MIDNIGHT
TEST TONE
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
2
3
5
0
6
9
+10
TV/VCR
CLASS
7
8
4
1
CHANNEL
MULTI CONTROL
ENTER
VOL
VOL
FQ
FQ
+
–
TV FUNC
AMP
TV
MUTING
CH.LEVEL
EFFECT
FL DIMMER
FUNCTION
DIRECT
MODE CHECK
COMMANDER
SET UP
Î
MEMU
