Using other functions
08
69
En
Chapter 8
Using other functions
Making an audio or a video recording
You can make an audio or a video recording from an
audio or video source connected to the amplifier (such as
a CD player or TV).
Keep in mind you can't make a digital recording from an
analog source or vice-versa, so make sure the
components you are recording to/from are hooked up in
the same way (see
Connecting your equipment
on
page 12 for more on connections).
You can record using composite and S-video
connections interchangeably, but you won’t be able to
record sources connected to the component video
inputs. See
About the video converter
on page 20 for more
on this.
For more information about video connections, see
Connecting a VCR or DVD recorder
on page 18 and
Connecting other video sources
on page 19.
1
Select the source you want to record.
Use the
INPUT
buttons (or the
INPUT SELECTOR
dial on
the front panel).
2
Select the input signal (if necessary).
Press
SIGNAL SELECT
to select the input signal
corresponding to the source component (see
Selecting
the input signal type
on page 44 for more on this).
3
Prepare the source you want to record.
Tune to the radio station, load the CD, video, DVD etc.
4
Prepare the recorder.
Insert a blank tape, MD, video etc. into the recording
device and set the recording levels.
Refer to the instructions that came with the recorder if
you are unsure how to do this. Most video recorders set
the audio recording level automatically—check the
component's instruction manual if you're unsure.
5
Start recording, then start playback of the source
component.
Note
• The amplifier's volume, tone (bass, treble, Midnight,
Loudness), and surround effects have no effect on
the recorded signal.
• Some digital sources are copy-protected, and can
only be recorded in analog.
• Some video sources are copy-protected. These
cannot be recorded.
Monitoring your recording
You can listen to (monitor) the recording as it’s being
made if you’ve connected a cassette deck with a
monitoring function to the
TAPE 2 MONITOR
jacks on
the rear panel.
•
Press TAPE 2 MONITOR to switch between the
recorded signal and the original source signal.
With the remote, you may need to press
on the
Home menu (
) first before reaching the amplifier
menu screen shown below (use the
/
(cursor left/
right) soft keys to go to the previous/next menu screen).
Tip
• To record the tape 2 monitor signal to a recorder
connected to the
CD-R/TAPE 1
inputs, select any
input (except
CD-R/TAPE 1
) and switch the tape 2
monitor on.
AMPLIFIER
AMPLIFIER
3/3
SB CH
MODE
INPUT
STATUS
INPUT
ATT
SPEAKER
A/B
VIDEO
SELECT
TAPE2
MONITOR
DISPLAY
DIMMER
AMPLIFIER
TV
CONT
PHONES
SP SYSTEM
A/B
SIGNAL
SELECT
VIDEO
SELECT
TAPE2
MONITOR
STREAM
DIRECT
SETUP
MIC
SB CH
MODE
DIGITAL IN
S-VIDEO
VIDEO
VIDEO INPUT
AUDIO
L
R
MIDNIGHT
LOUDNESS
OPTION
TONE
DIGITAL NR
INPUT ATT
SELECT
CH LEVEL
ACOUSTIC
CAL.
