−
15
−
English
Installation
Specified Installation Position on Front Windscreen
When installing this product to the inside of the front windscreen, install in a vehicle and in a position
that satisfies all of the following conditions.
• A position where this entire product is within 20% of the top edge of the height of the front
windscreen (range within 20% of the actual length, excluding parts overlapping weatherstrips,
mouldings, etc. and masked parts) or is in the shadow of the rear view mirror as viewed from the
driver’s seat.
Note that “20%” as described above is a rough estimate. Please install the product in accordance
with your country’s laws and regulations.
• A position in which the mounting bracket is at least 2 cm below the top edge of the front windscreen.
• A position where the lens part of this product is within the wiping range of the wiper.
• A position where the lens part of this product does not hang over the sunshade and black ceramic
lines/black ceramic pattern.
• A position where this product faces in the horizontal direction to the front and side to side.
• A position where the power cable can be routed without unnecessary force.
Installation Direction
Horizontal Direction
This product
Front Windscreen
Ground
This product
Horizontal Direction
This product
This product
* Install this product in a location
where it will not interfere with the
driver’s field of view.
Installation Angle
Allowable Installation
Angle: 15˚ to 70˚ (With Lens
Horizontal)
Front
Windscreen
Forward Direction
of Vehicle
Within 20% of Height
Rear View Mirror
Range of Windscreen Wipers
A Pillar
A Pillar
Air Bag
* Even if installed within the allowable
installation angles, depending on
the vehicle the lens may not become
horizontal. Please check this prior to
mounting.
Gap of at Least 2 cm
Installation Area
IMPORTANT
Always install this product in the specified installation position to ensure a safe field of view while driving
and to achieve full performance from the product.
