1 Press FUNCTION to select AUX1/AUX2.
Press
FUNCTION
repeatedly until
AUX1
/
AUX2
appears in the display.
2 Press
a
or
b
to turn AUX1/AUX2 on or
off.
Pressing
a
or
b
will turn
AUX
on or off and
that status will be displayed (e.g.,
AUX1 :ON
).
Setting the rear output and
subwoofer output
This unit
s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
R-SP :FUL
) or subwoofer
(
R-SP :S/W
) connection. If you switch the rear
output setting to
R-SP :S/W
, you can connect
a rear speaker lead directly to a subwoofer
without using an auxiliary amp.
1 Press FUNCTION to select R-SP.
Press
FUNCTION
repeatedly until
R-SP
ap-
pears in the display.
2 Press
a
or
b
to switch the rear output
setting.
Pressing
a
or
b
will switch between
R-SP :FUL
(full-range speaker) and
R-SP :S/W
(subwoofer) and that status will be displayed.
#
When no subwoofer is connected to the rear
output, select
R-SP :FUL
.
#
When a subwoofer is connected to the rear
output, set for subwoofer
R-SP :S/W
.
#
When the rear output setting is
R-SP :S/W
,
you cannot change the subwoofer controller.
Notes
!
Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to
Using subwoofer output
on page
34).
!
If you change this setting, subwoofer output
in the audio menu return to the factory set-
tings.
!
Both rear speaker leads outputs and RCA rear
output are switched simultaneously in this
setting.
Initial Settings
En
38
Section
09
