Adjusting initial settings
1
Using the initial settings, you can customize
various system settings to achieve optimal per-
formance from this unit.
1
Function display
Shows the function status.
1 Press SOURCE and hold until the unit
turns off.
2 Press SOURCE and hold again until the
clock appears in the display.
3 Press FUNCTION to select one of the in-
itial settings.
Press
FUNCTION
repeatedly to switch be-
tween the following settings:
Clock
WARN
(warning tone)
AUX1
(auxili-
ary input1)
AUX2
(auxiliary input2)
R-SP
(rear output and subwoofer controller)
Use the following instructions to operate each
particular setting.
#
To cancel initial settings, press
BAND
.
#
You can also cancel initial settings by holding
down
SOURCE
until the unit turns off.
Setting the clock
Use these instructions to set the clock.
1 Press FUNCTION to select clock.
Press
FUNCTION
repeatedly until clock ap-
pears in the display.
2 Press
c
or
d
to select the segment of
the clock display you wish to set.
Pressing
c
or
d
will select one segment of the
clock display:
Hour
Minute
As you select segments of the clock display
the segment selected will blink.
3 Press
a
or
b
to set the clock.
Pressing
a
will increase the selected hour or
minute. Pressing
b
will decrease the selected
hour or minute.
Switching the warning tone
If the front panel is not detached from the
head unit within five seconds of turning off the
ignition, a warning tone will sound. You can
turn off the warning tone.
1 Press FUNCTION to select WARN.
Press
FUNCTION
repeatedly until
WARN
ap-
pears in the display.
2 Press
a
or
b
to turn WARN on or off.
Pressing
a
or
b
will turn
WARN
on or off and
that status will be displayed (e.g.,
WARN :ON
).
Switching the auxiliary setting
Auxiliary equipments connected to this unit
can be activated individually. Set each AUX
source to ON when using. About connecting
or using auxiliary equipments, refer to
Using
the AUX source
on page 39.
Initial Settings
En
37
English
Section
09
