Easy Installation Power Meter Cranksets
with ANT+ Cycle Computer
1.) Magnet Placement
(Optional
)
•
Measuring from the center of the bottom bracket out,
temporarily tape the magnet so that the center line of the
magnet is:
•
Right Drive Side - 42mm
•
Left Side - 53mm
•
Use the supplied Magnet Placement Template to help locate
the optimum locations for magnet placement on the frame.
•
Position the magnets so the sensor line and magnet center
line are parallel when the sensor passes over.
Center hole on bottom bracket and use supplied
double sided tape to temporarily secure while locating
optimum magnet location
Sensor Line:
Magnet
Center
Line:
Magnet Range
1.5mm
– 10.7mm
Magnet Template
card
2.) Confirm Magnet Placement
•
Remove and replace both Left and Right batteries. Orange light will appear for 10 seconds.
•
Rotate the crank slowly (30rpm). Check that the LED on each sensor lights green once for each
revolution.
•
Once confirmed, secure magnets for final placement.
If no
Green
LED,
check and adjust
magnet placement
LED’s light green
3.) Pair to your ANT+ Computer
•
Spin the crank 3
– 4 rotations to activate the Power Meter
See your ANT+ Cycle Computer
Instructions for Power Meter Pairing and
Zero Calibration procedures.
ID 12345
Sensor ID
Left Sensor Arm
For additional Installation Instructions visit the following on-line support
locations
www.pioneerelectronics.com/PUSA/Cycle+Sports/Products/Power+Meters
www.Youtube/Pioneer Cycle Sports USA
Please refer to the owners manual for detailed installation instructions.
Visit
for the latest firmware and updates.
Customer Support
– 1-800-421-1624
E-Mail: [email protected]
