90
SDV-P7
-
Handling the mechanical module
1. The mechanical module should be handled by holding
the upper frame and main frame of the mechanical mod-
ule.
2. The front section of the upper frame is not very sturdy,
so this section should not be held too firmly (see fig. 3).
-
Removing the DVD Core Unit V
1. Bring the mechanism to a locked position (disk load
standby position).
2. Turn the mechanical module upside down.
3. Set the pick-up flexible cable to a shorted position on
the land end (the other is auxiliary), and turn the SW
knob in the direction opposite to OP (see fig. 4).
4. Remove the pick-up flexible cable and the CRG flexible
cable from the connector. Remove the solder on the
lead wires of the load motor.
5. Remove a screw and two solders then remove the hold-
er.
6. Remove screws at three locations, and remove the
DVD Core Unit V (lift the board in the direction of the
white arrow shown in fig. 5, and remove it out diago-
nally).
Removing the PU unit (see fig. 6)
1. Lift the pick-up rack to the center of the axis of the rack,
turn it 90 degrees first, then press on it lightly, and fix it
2. Remove the screw that keeps the main shaft clamp spring in
place, and remove the main shaft clamp spring.
3. Remove the PU unit with the main shaft attached.
Do not hold onto this area.
Short
Auxiliary
land
Fig. 3
Fig. 4
Fig. 5
DVD Core Unit V
Holder
Fig. 6
Main shaft
CRG motor
PU unit
PU rack
Main shaft
clamp spring
www. xiaoyu163. com
QQ 376315150
9
9
2
8
9
4
2
9
8
TEL 13942296513
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
