Locate the wall thermostat, handheld
remote controller, batteries, thermostat
support bracket, and extension cable.
These items are typically found within
the hidden compartment on top of the
system itself during first installation.
Using two wood screws to fix the
bracket of the thermostat to the wall,
connect the extension cable to the wall
thermostat and place the thermostat
onto the support bracket.
A 3/4” size hole must be drilled in
order to pass the cables through. The
wall thermostat cable will pass through
this hole from behind.
To locate where to make the hole, first
find the needed
X
value by placing the
3”-3/8 square wall thermostat
against the wall. The length from the
side edge of the thermostat to the side
edge of the wall is
X
. The same applies
for finding
Y
on the vertical axis.
The center of the hole will be X+1”-3/4
inward from the side, and Y+1”-1/8
inward from the top.
19
|
(800)-675-7410
|
https://www.pdhvac.com/support/
I
NSTALLATION
I
NSTRUCTIONS
Placement of the Wall Thermostat
Cable
Outlet Slot
3” - 3/8
3/4”
X + 1” - 3/4
Y + 1” - 1/8