39
Additional Information
Troubleshooting
Table of Remote Control Unit Menu
Displays
Index
?
Problems
with Use or
Operation?
P16
P10
P14
P11
Can’t recharge remote control unit
Check the recharge indicator in the upper right corner of the remote
control unit’s touch panel to confirm whether the remote control unit is
sitting on the recharger and recharging correctly.
If the remote control unit’s battery won’t hold a sufficient charge to allow
use of the remote control unit even after proper recharging, the unit’s
Lithium-ion battery may require replacing. In this event, consult your
authorized Pioneer service center. The remote control unit’s Lithium-ion
battery cannot be purchased at any location other than an authorized
Pioneer service center.
Remote control unit doesn’t work
Check that the main power switch is turned on, the power cord is con-
nected securely, and the front panel’s POWER ON (Blue) or STANDBY
(Red) indicator is lighted.
Check the remote control unit’s remaining charge indicator to confirm that
the remote control unit’s battery is properly recharged.
You may be using the remote control too far from the sensor (Try moving
closer to the digital sound projector).
Remote operation may become unreliable if direct sunlight, a fluorescent
lamp, or other strong light source is striking the remote control sensor on
the front panel.
Remote control unit doesn’t operate connected Pioneer DVD recorder
Depending on the model, some functions may not be supported.
Touch panel menus don’t change
If the remote control menu screens do not change, try using the following
procedure to reset the remote control unit. Resetting the remote control
unit will not erase recorded settings.
If the unit does not operate normally due to external effects (such as
static electricity)
Disconnect the power plug from the outlet and insert again to return to
normal operating conditions.
Resetting the Remote Control Unit
RE
SE
T
RE
SE
T
RE
SE
T
1
Use a Phillips screwdriver
to remove the screw on
the back panel of the
remote control unit.
2
Remove the panel.
3
Use a narrow pointed
object to press the RESET
button.
