15
En
Installation and Connections
Fran
ç
ais
English
Control Cord Connection
When control cord connections are made, remote control
operation of connected PIONEER components that bear
the
Î
logo mark is done through the remote sensor on
this unit.
When the connection is made to the CONTROL IN
terminal on another unit, the remote sensor of that
component will no longer receive signals. Point the
remote control unit of the connected component at the
remote control sensor on this unit to control.
Notes
÷
Make sure the power is turned off when making
connections.
÷
Please complete all component connections before
making control cord connections.
CONTROL
IN
OUT
CONTROL
IN
OUT
CONTROL
IN
OUT
IN OUT
CONTROL
Installation and Connections
The control cables (not
supplied) are monaural
cables with mini plugs (no
resistance).
Main unit
Power Cord Connection
Connect a power cord after all component connections
have been completed.
PDP-503MXE / PDP-433MXE power cord ratings
Cord .......................... Cross-sectional area 3 x 1.0 mm
2
(According to CEE 13)
Connector ................................................... 10 A, 250 V
(According to EN60320 Sheet C13)
Plug ................................ International use (10 A, 250 V)
Example:
UK
: UK 13 Amp Plug with rated 13 Amp fuse
(According to BS1363)
EURO : 10 A/16 A 250 V (According to CEE 7, 1 V)
CAUTION
÷
Do not use a power supply voltage other than that indicated
(AC 100 - 240 V, 50/60 Hz) as this may cause fire or electric
shock.
÷
For the plasma display, a three-core power cord with a ground
terminal is used for efficiency protection. Always be sure to
connect the power cord to a three-pronged grounded outlet
and make sure that the cord is properly grounded. If you use a
power source converter plug, use an outlet with a ground
terminal and screw down the ground line.
Attaching the Ferrite Core
To help prevent noise, attach the accessory ferrite core to
the plug end of the power cord as shown in the
accompanying illustration. Use the provided cable tie to
prevent the ferrite core from slipping on the cable.
Ferrite core
Cable tie
AC power cord
To power
outlet
As close as possible
To AC INLET