13
En
En
g
lis
h
ILLUMINATION settings
Menu Item
Description
DIM SETTING
[SYNC CLOCK], [MANUAL]
Change the display brightness.
BRIGHTNESS
[1] to [10]
Change the display brightness.
The available setting ranges differ
depending on [DIM SETTING].
MIXTRAX settings
Menu Item
Description
SHORT PLAYBCK
[1.0 MIN], [1.5 MIN], [2.0 MIN],
[2.5 MIN], [3.0 MIN], [OFF]
Select the length of the playback time.
MIX PATTERN
[SOUND LEVEL]
Change the MIXTRAX special effects
according to the audio level.
The mix pattern changes according to
the sound level.
[LOW PASS]
The mix pattern changes according to
the bass level.
[RANDOM]
The mix pattern changes randomly
according to the sound level mode and
low pass mode.
DISPLAY FX
[ON], [OFF]
Set the MIXTRAX special effects on/off.
CUT IN FX
[ON], [OFF]
Turn the MIXTRAX sound effects on/off
while manually changing the tracks.
WARNING
•
When speaker output is used by 4
channels, use speakers over 50 W
(maximum input power) and
between 4 Ω to 8 Ω (impedance
value). Do not use 1 Ω to 3 Ω
speakers for this unit.
•
When rear speaker output is used by
2 Ω of subwoofer, use speakers over
70 W (maximum input power).
* Please refer to connections for a
connection method.
•
The black cable is ground. When
installing this unit or power amp
(sold separately), make sure to
connect the ground wire first. Ensure
that the ground wire is properly
connected to metal parts of the car’s
body. The ground wire of the power
amp and the one of this unit or any
other device must be connected to
the car separately with different
screws. If the screw for the ground
wire loosens or falls out, it could
result in fire, generation of smoke or
malfunction.
Important
•
When installing this unit in a vehicle
without an ACC (accessory) position
on the ignition switch, failure to
connect the red cable to the terminal
that detects operation of the ignition
key may result in battery drain.
•
Use this unit with a 12-volt battery
and negative grounding only. Failure
to do so may result in a fire or
malfunction.
•
To prevent a short-circuit,
overheating or malfunction, be sure
to follow the directions below.
– Disconnect the negative terminal
of the battery before installation.
– Secure the wiring with cable
clamps or adhesive tape. Wrap
Connections/Installation
Connections
Ground wire
POWER AMP
Other devices
(Another electronic
device in the car)
Metal parts of
car’s body
*1 Not supplied for this unit
ACC position
No ACC position
