- 32 -
En
g
lis
h
This unit features two operation modes: network mode and standard mode. You can
switch between modes as desired (page 11).
Network mode
You can create a 2-way + SW multi-amp and multi-speaker system with high range
speaker, middle range speaker and subwoofer for reproduction of high, middle and low
frequencies (bands).
Standard mode
You can create a 4-speaker system with front and rear speakers or front speakers and
subwoofers, or a 6-speaker system with front and rear speakers and subwoofers.
You can adjust the cut-off frequency value and the slope value of each speaker.
The following speakers can be adjusted.
Network mode:
[HIGH] (high-range speaker HPF), [MID HPF] (middle-range speaker HPF), [MID LPF]
(middle-range speaker LPF), [SUBWOOFER]
Standard mode:
[FRONT], [REAR], [SUBWOOFER]
NOTE
[SUBWOOFER] can only be selected when [ON] is selected in [SUBWOOFER] (page 37).
1
Press the
M.C.
dial to display the main menu.
2
Turn the
M.C.
dial to select [AUDIO], then press to confirm.
3
Turn the
M.C.
dial to select [CROSSOVER], then press to confirm.
4
Turn the
M.C.
dial to select the speaker unit (filter) to be adjusted, then press to
confirm.
5
Turn the
M.C.
dial to select [HPF] or [LPF] according to the speaker unit (filter),
then press to confirm.
6
Turn the
M.C.
dial to select an appropriate cut-off frequency for the speaker unit
(filter) selected in step 4, then press to confirm.
Network mode:
[1.25K] to [12.5K] (if you choose [HIGH] or [MID LPF])
Operation modes
Adjusting the cut-off frequency value and the slope
value
