Pioneer FH-XL555UI, Owner'S Manual

Page: 16 / 116

i
Yellow/black (FH-XL555UI only)
If you use an equipment with Mute function,
wire this lead to the Audio Mute lead on that
equipment. If not, keep the Audio Mute lead
free of any connections.
j Subwoofer (4
W
)
k
When using a subwoofer of 70 W (2
W
), be
sure to connect the subwoofer to the violet
and violet/black leads of this unit. Do not
connect anything to the green and green/
black leads.
l
Not used.
m
Subwoofer (4
W
) × 2
Notes
!
With a 2 speaker system, do not connect any-
thing to the speaker leads that are not con-
nected to speakers.
!
Change the initial menu of this unit. Refer to
SP-P/O MODE (rear output and preout set-
ting) on page 14.
The subwoofer output of this unit is monau-
ral.
Power amp (sold separately)
Perform these connections when using the op-
tional amplifier.








1
1
3
2
4
5 5
3
2
6
7 7
1
System remote control
Connect to Blue/white cable.
2
Power amp (sold separately)
3
Connect with RCA cables (sold separately)
4 To Front output
5
Front speaker
6
To Rear output or subwoofer output
7
Rear speaker or subwoofer
Installation
Important
!
Check all connections and systems before
final installation.
!
Do not use unauthorized parts as this may
cause malfunctions.
!
Consult your dealer if installation requires
drilling of holes or other modifications to the
vehicle.
!
Do not install this unit where:
—
it may interfere with operation of the vehicle.
—
it may cause injury to a passenger as a result
of a sudden stop.
!
The semiconductor laser will be damaged if
it overheats. Install this unit away from hot
places such as near the heater outlet.
!
Optimum performance is obtained when the
unit is installed at an angle of less than 60°.
60°
!
When installing, to ensure proper heat dis-
persal when using this unit, make sure you
leave ample space behind the rear panel and
wrap any loose cables so they are not block-
ing the vents.
5cm cm
Leave ample
space
5 cm
5 cm
!
Use commercially available parts when in-
stalling.
Installation using the screw
holes on the side of the unit
%
Fastening the unit to the factory radio-
mounting bracket.
Position the unit so that its screw holes are
aligned with the screw holes of the bracket, and
tighten the screws at 3 locations on each side.
!
Toyota vehicles
1
1
Factory radio mounting bracket
!
Nissan vehicles
1
1
Factory radio mounting bracket
1
2
4
3
1
If the pawl gets in the way, bend it down.
2
Factory radio mounting bracket
3
Truss (5 mm × 8 mm) screws
4 Dashboard or console
Installation
16
Section
Installation
En
03
<CRD4707-A/N>16