Additional information
16
55
En
English
Français
Deutsch
Nederlands
Italiano
Español
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie in
another component. Investigate the other components and electrical appliances being used. If the
trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer
authorized service center or your dealer to carry out repair work.
• If the unit does not operate normally due to external effects such as static electricity
disconnect the power plug from the outlet and insert again to return to normal operating
conditions.
General
Problem
Remedy
The power does not turn on.
• Connect the power plug to the wall outlet.
• Disconnect the power plug from the outlet, and insert again.
• Make sure the power source is the right voltage for the AC inlet.
The power suddenly switches off
automatically and won’t switch
back on for a minute or so. Also,
the timer indicator is blinking.
• If the speaker cables aren’t connected properly, the system has a safety
feature that shuts the power off automatically. Check the speaker wires to
make sure they’re connected properly. If there appears to be nothing
wrong, try switching the power back on after the timer indicator has been
blinking for a minute or so.
• If you can’t seem to switch the power back on after the timer indicator
has been blinking for over a minute, the unit may be malfunctioning. Take
it to your nearest Pioneer authorized service center or your dealer to carry
out repair work.
No sound is output when a
function is selected.
• If you’re using the
LINE
input, make sure the component is connected
correctly (see
Connecting auxiliary components
on page 12).
• Press
MUTE
on the remote control to turn muting off.
• Adjust the volume.
No image is output when
watching discs.
• Make sure the TV is connected correctly (see
Connecting to your TV
on
page 11).
Can’t operate the remote
control.
• Replace the batteries (see
Loading the batteries
on page 6).
• Operate within 23 feet (7 m), 30° of the remote sensor on the front panel
(see
Range of the remote control unit
on page 6).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
The microphone can’t be heard.
• Stop the disc, then restart playback.
• You are only using one microphone and it’s plugged into the
MIC (SUB)
jack. The
MIC (SUB)
jack can only be used if there is also a microphone
plugged into the
MIC (MAIN)
jack.
• Adjust the
MIC VOL
.
Feedback noise when mic is
switched on.
• The mic is pointing toward the speakers. Keep the mic pointed away
from the speakers.
• The microphone level is set too high. Turn down the mic control level.
EV-5_7_9.book 55 ページ 2006年4月3日 月曜日 午後9時29分