English
Français
Connecting up
02
11
En
Connecting audio components
The number and kind of connections depends on the kind of component you’re connecting. Follow the steps below to
connect a tape deck, turntable or other audio component.
1
Connect the analog outputs of your tape deck (or
other recorder) to the LINE IN jacks on this receiver.
Then connect the audio inputs on the tape deck to the
LINE OUT jacks on this receiver.
This will allow you to make recordings from the
components connected to this receiver. Use stereo RCA
pin-plug cables as shown.
2
Turntables only:
Connect the audio outputs of your
turntable to the PHONO IN jacks on this receiver.
• If your turntable has a grounding wire, secure it to the
ground terminal on this receiver.
• If your turntable has line-level outputs (i.e., it has a
built-in phono pre-amp), connect it to the
LINE IN
jacks instead.
• Use only turntables equipped with MM type
cartridges.
3
Connect the front panel F.AUDIO IN mini-plug jack
to an auxiliary playback component.
These include components like a digital audio player or
the analog audio output of a PC. Connect using a
1
/
4
”
stereo mini-plug cable.
1
4
Connect any iPods, USB mass storage devices, and/
or network components.
You can listen to music stored on such components from
Home Media Gallery (page 19).
Plugging in
Make sure to complete all connections before
connecting to an AC IN inlet.
Connect the AC power cord to the AC IN inlet on the rear
panel of the receiver, then plug into a power outlet.
Home Media Gallery
TIMER
DISPLAY OFF
STANDBY/ON
USB
SOUND RETRIEVER
PHONES
F. AUDIO IN
AC IN
R
OUT
LAN
(10/100)
IN
IN
IN
IN
IN
L
LINE
LINE
XM
RADIO
PHONO
iPod
USB mass
strage device
Digital audio player, etc.
Front panel
Tape deck, etc.
Turntable
To analog
audio inputs
From analog
audio outputs
From analog
audio outputs
iPod
Router
(not suppulied)
Network
Rear panel
1
2
3
4
MENU
iPod
Music >
Extras >
Settings >
Shuffle Songs
Backlight
Note
1 The system automatically switches the input to
FRONT AUDIO IN
when you connect a mini-jack cable to the front panel (except when wake-up timer is
set for power ON).
X-Z9_KU.book 11 ページ ２００７年７月２日 月曜日 午後５時３３分
