41
05
Basic playback
Playing a USB device
It is possible to play files using the USB interface on the front of this receiver.
!
Compatible USB devices include external magnetic hard drives, portable flash memory drives (particularly key
drives) and digital audio players (MP3 players) of format FAT16/32.
!
Pioneer cannot guarantee compatibility (operation and/or bus power) with all USB mass storage devices and
assumes no responsibility for any loss of data that may occur when connected to this receiver.
1 Press
u
RECEIVER to switch on the receiver and your TV.
See
Connecting a USB device
on
page 31
.
About one minute is required between turning the power on and completion of startup.
!
Make sure the receiver is in standby when disconnecting the USB device.
2 Press iPod USB on the remote control to switch the receiver to the iPod/USB.
Loading
appears in the GUI screen as this receiver starts recognizing the USB device connected. When the dis-
play shows the names of folders and files, you’re ready to play from the USB device.
Note
If an
Over Current
message lights in the display, the power requirements of the USB device are too high for this
receiver. Try following the points below:
!
Switch the receiver off, then on again.
!
Reconnect the USB device with the receiver switched off.
!
Use a dedicated AC adapter (supplied with the device) for USB power.
If this doesn’t remedy the problem, it is likely your USB device is incompatible.
Playing back audio files stored on a USB memory device
The maximum number of levels that you can select in Step 2 (below) is 9.
!
Note that non-Roman characters in the playlist are displayed as #.
1 Use
i
/
j
to select a folder, then press ENTER to browse that folder.
!
To return to the previous level any time, press
RETURN
.
2 Continue browsing until you arrive at what you want to play, then press
d
to start
playback.
!
Copyrighted audio files cannot be played back on this receiver.
!
DRM-protected audio files cannot be played back on this receiver.
Basic playback controls
This receiver’s remote control buttons can be used for basic playback of files stored on USB memory devices.
!
Press
iPod USB
to switch the remote control to the iPod/USB operation mode.
TOP MENU
ENTER
RETURN
DISP
Playing back photo files stored on a USB memory device
!
Photo files cannot be played in the sub zone.
1 Use
i
/
j
to select a folder, then press ENTER to browse that folder.
!
To return to the previous level any time, press
RETURN
.
2 Continue browsing until you arrive at what you want to play, then press ENTER to start
playback.
The selected content is displayed in full screen and a slideshow starts.
Basic playback controls
Button(s)
What it does
ENTER
,
d
Starts displaying a photo and playing a slideshow.
g
Stops the player and returns to the previous menu.
Tip
!
Slideshows of photo files can be played while listening to music files by returning to the folder/file list display
while playing a music file on a USB device then playing the photo files.
